Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Hi, X, Y and Z axis home normally in marlin v1.1.8. But error occurred in homing of X and Y in marlin v2.1.1, it shows "Error: Printer halted. kill() called!". However Z homing is normal. The endstop setting in marlin v1.1.8 is the same as v2.1.1.
by
hanks
-
Printing
I have found out the cause of the problem. The chip of the board is broken.
by
hanks
-
Printing
Hi
Whether the X endstop is triggered or released, it shows "x_min: TRIGGERED" when send M119 note. Maybe this pin is broken. Thanks.
by
hanks
-
Printing
Hello
The pin of X-,X+,Y-,Y+,Z-,Z+ on the RAMPS 1.6 board are no voltage or low voltage(0.28V), that cause the endstop to fail. When the motors are back to origin, the motor moves a small distance in the positive direction instead of moving in the negative direction. And the LCD12864 display "Endstop X/Y/Z". Does it mean that the main control chip is broken? The fact is the same, after I re
by
hanks
-
Printing