Show all posts by user
Printing issues ...
Page 2 of 2
Pages: 12
Results 31 — 33 of 33
Well, I got pictures. I don't have to tap it at all, it just slides right through. It's printed in PLA but I don't think the screws here are worth salvaging.
by
Tempest815
-
Smart_Rap
The screws going down to hold the base to the board, I believe they're 25mm so that's probably part of my problem. 25mm just barely pokes through the board on the y axis mounts. I'm gonna end up reprinting it, I think, getting them out seems difficult at best and then there's the issue with the Z axis rods being super loose.
by
Tempest815
-
Smart_Rap
I guess this place is as good as any to ask...
I'm building the Funbot, and I've run into some real beginner issues. Namely, I think I've stripped the heads of the screws I was attempting to use for the Zbase. So I'm thinking I'm screwed on that part, going to need to get another one. Any way to salvage? They're almost threaded through the base itself, almost enough to tack it in place on the ba
by
Tempest815
-
Smart_Rap
Page 2 of 2
Pages: 12