Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
I am printing a calibration square that is 100mm x 100mm x 5mm high with 5mm walls. I can get the O.D. to print out with .03 to .05 accuracy. My problem is that the walls turn out to be 5.2 to 5.4 thick. What settings do I need to change to get the thickness of the walls accurate? I've tried everything I can think of.
by
mikemwa
-
Slic3r
Same windows I'm using.
by
mikemwa
-
Slic3r
Francois Wrote:
-------------------------------------------------------
> There is no manual per say, AFAIK.
> Have you seen these pages ?
I don't understand why there would'nt be a manual or at least a section with all the settings and explinations of what they are, defaults, and what happens when you change the settings. It would sure help all of us that are new to the program. Plus ther
by
mikemwa
-
Slic3r
For the last couple versions, when I use Slic3r, after about 30 seconds or so the tab I'm working in will disappear. If I click another tab and go back to the one I was working in it will be ok for another 30 seconds or so and disappears again. It's very annoying. I did'nt have this problem in 7.2. Is there any way to fix this?
by
mikemwa
-
Slic3r