Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Thanks for all the suggestions - that's quite something to chew on. So I did re-check the filament size and the belt tension - took quite some time to take it apart and reassemble, but seems that everything is/was ok in that area. Same with the bed leveling. So far nothing changed and I am now looking into the amount of extruded material and maybe an issue with nozzle-size and extrusion speed.
A
by
ByronStar
-
Slic3r
That's already a very good question. I did not touch those settings yet and the Slic3r defaults are 30mm/s for perimeters and 60mm/s for infill. First Layer speed at 30%.
The e-steps calibration I did with 30mm/s.
by
ByronStar
-
Slic3r
I am calibrating a ShaperCube 2.1.2 with a 0.25 nozzle running Marlin Firmware, Slic3r 0.9.5 and Repetier-Host Mac 0.51 printing with ABS. The e-steps are measured and calibrated to the exact mm. When I started with the thin wall object it took quite some time to get to decent results, but finally it looks quite ok with .21mm and as well .18mm layer hight. The extrusion multiplier is at 1.0 and t
by
ByronStar
-
Slic3r