Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Thanks for all the input.
I've drawn a 20 x 20 x20mm cube to use as a test model.
I have updated Slic3r to 1.3.0 dev, and checked the G-code manually ( A bit of a long job, but using nraynaud.github.io website made it a bit easier; can anyone suggest a more friendly site?).
Also, is it possible to update Slic3r to a fully released version of 1.3.0?
In Slic3r settings adaptive slicing, I note
by
Davedave
-
Slic3r
Thanks! However the layer height seems ok, since 15 layers works out at 3.0mm and it printed at 3.01mm. The error is in the X and Y directions, leading to larger and smaller layer areas.
I, too suspect Slic3r, so I'll read up about microstepping, adjust potentiometers and give it a try.
by
Davedave
-
Slic3r
For a model with vertical sides my prints show that the layers have different sizes, according to a regular pattern.
This shows up when I use aligned seam arrangement so that layers should be exactly the same.
In the attached file for model 'deer' there are 15 layers of 0.2mm layer height giving a design height of 3.0mm. Actual height is 3.01mm.
The pattern 3 big layers(b), followed by 1 smal
by
Davedave
-
Slic3r
Have looked on North East Users Group forum, but there is only sporadic posts over the last 2 years or so.
Can anyone tell me whether this group is still in existence, and whether they still use the site / amalgamated with another site / have another channel of communication or what?
thank in anticipation ...
by
Davedave
-
United Kingdom RepRap User Group
