Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Hi!
Thank you for the many suggestions, I will go on trying
Best regards
Falk
by
smoothcriminal
-
Slic3r
Hi Dave,
thank you for your explanation, but I can confirm, that the outstanding layer is not depending on the direction.
It comes after each fast solid infill.
But what speed I ever set for the different options, the result stays the same.
Falk
Edit:
See attachment.
Slic3r makes huge "solid" areas (2) for printing only little "caves" (1) in the perimeters.
Which setting affects this areas?
A
by
smoothcriminal
-
Slic3r
Hi,
Here it is.
Falk
by
smoothcriminal
-
Slic3r
Hi!
Since a few weeks I own an Ultimaker 2.
After some relatively good prints I encountered some problems with Cura on negative angles.
After some reading in the Internet I recently switched to Slic3r.
The prints are much better but I got some new problems.
In the attached image you can see the marked outstanding perimeters.
I figured out, that they only appear if the printer prints some infill,
by
smoothcriminal
-
Slic3r
