Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
@RothStar,
Where does the program place the output file? (Win64)
thanks, nutz
by
nutz
-
Slic3r
LVD,
Thanks for the cogent reply. It is much appreciated. Any help at this juncture is appreciated as I am clueless about how to remedy things.
Thanks
nutz
by
nutz
-
Delta Machines
Quotehercek
Well, if you know about JTAGICE then it looks like you can do some limited programming. So you can eventually figure it out even with 8-bit electronics. As for as the calibration, get a z-probe and calibrate using numerical methods:
Or just get a new electronics which works with dc42's firmware and calibrate with it.
Hercek,
I looked through your github code, impressive, and thank
by
nutz
-
Delta Machines
DC42,
Thanks for the tip. I previously located and reviewed your website, your homebrews and of course your Differential IR Z-Probe sensor, which I plan to purchase, as soon as I complete my wireless possum trap. Catch, move, and release that critter that is eating much of my pheral community kitties' dindins. A bit like feeding illegals, just too many for the wallet, here in the United States o
by
nutz
-
Delta Machines
Hello,
I appologize regarding length.
Intro
I've been following 3D printing for years. It is such a kewl idea and it works too, it's nut just sci-fi.
Frankly I cotton to the delta theme, these robots are so sexy. )
But in any case, after expending many days on the web, I convinced myself that I could
make a delta from scratch and inexpensively too. In retrospect, I should have just bought
by
nutz
-
Delta Machines
The part appears to be rod that is slightly smaller diameter than the rod-end bearing that rides on it. Both ends of the shaft can be seen to be tapped or 'threaded', while one end has been turned to a smaller diameter. Turn-buckles are typically flat-sided so that a wrench may be used to turn the mechanical part. You can make the part by purchasing smooth rod, cutting it to length with a hack-sa
by
nutz
-
Delta Machines
My guess is the other fellow is citing the two thin funky light brown/yellow square thingies on the Ramps board. Those look to me to be self-resettable 'fuses'. If those things are self resetting poly-fuses, and they over-heat in that application then either they are failing, or are improperly manufactured or are undersized for the intended load current. In any case there is something not correc
by
nutz
-
Delta Machines