Show all posts by user
Page 7 of 7
Pages: 34567
Results 181 — 190 of 190
Hey,
Thank you for your suggestion tjb,
As my set temp was 180*C I decided to actually get a digital thermometer and check what the actual temp was on the hot end.
Turn out it was only 150-160*C And i know that PLA should be another 20-30*C higher than that value. I have now set it to 200*C and it seems to be printing much better! I will update when the print is finished.
Thanks again,
ayoud
by
ayouden
-
General
Hey,
I have got my printer printing recognisable shapes at long last, however the finish is a bit rough in places.
I have noticed that there are bands of perfect edges and layers. In the photo attached you can definitely see the darker bands. (dark bands are at the base and just below my fingers)
So my question is, what causes these bands and how do I make it fully dark so I can get nice clean
by
ayouden
-
General
Hey,
Thank you for all your suggestions about this topic.
I found a solution which works for me at least, what I have done is set the infill speed to 20 rather than the default 60 in Repetier. I very rarely get any faults on the infill now and my prints are becoming much stronger because of it.
Thanks
by
ayouden
-
General
Hey,
I am having some issues with the infill on my RepRap Prusa i2.
I tried slowing the speed of the infill layers down, but that didn't help much.
The layer height is 0.1mm and i am not using a cooling fan.
Could this be the reason?
Attached is a photo of what the print looks like
Thanks, Alex
by
ayouden
-
General
Hey,
I didn't think this was a extruding amount issue, so I will increase the steps per mm it and see if that helps.
thank you for your suggestion.
Alex
by
ayouden
-
Reprappers
Hey,
I have had this issue for a while now and I have not come to a fix.
My printer doesn't seem to be doing a complete full top layer. as you can see from the images attached, there are some noticeable holes and it isn't solid!
Has anyone had this issue before, or do you know how to fix this?
Thanks very much!
Alex.
by
ayouden
-
Reprappers
Hey,
Does anyone have a tutorial on how to change the config.h tab for Repetier Firmware for a Delta 3D Printer using a Sanguinololu board
I have no idea what any of the options are and what my Printer is set to?
Thanks
by
ayouden
-
Firmware - mainstream and related support
Yea I have, but they are not answering phone calls or replying to emails...
by
ayouden
-
Delta Machines
Hey,
After doing some research i think i have found out why my 3D printer isn't working properly, I think it is due to having the wrong firmware. The Sanguinololu board (with ATMEGA1284P#) has Marlin already installed, and I am using Repetier software on my PC.
The printer I am using is a delta style.
I have had a quick look at the compatible firmware for the board and Repetier is not on the l
by
ayouden
-
Delta Machines
Hello,
I am having trouble setting up the Delta with the Repetier-Host software on my PC. I am using lead-screws and I have calculated the steps per mm.
does anyone have a set-up guide or manual for this?
If anyone was wondering, the printer I have is the SUMPOD Delta.
Thanks.
by
ayouden
-
Delta Machines
Page 7 of 7
Pages: 34567