Show all posts by user

Re: Calibration Problems with Repitier firmware and repitier host. - 12 years ago

Hi there, Thank you both for your responses.. I was able to change the direction of the x axis via the configuration changing "#define INVERT_X_DIR true" to "#define INVERT_X_DIR false" I also copied the settings word for word what you said above.. /* By default all endstops are pulled up to HIGH. You need a pullup if you use a mechanical endstop connected with GND. Set value to false for no

by paulharrington - Repetier

Calibration Problems with Repitier firmware and repitier host. - 12 years ago

I recently installed the repetier firmware onto my arduino and when i begin to control it through the Repetier host there are number of things not working or wrong. These are being controlled via the "manual control" I am running the most recent firmware (Repetier_.83) and host. (V.90c) x-axis works fine but in reverse y-axis works fine but in reverse z- axis only raises, it will not lower towa

by paulharrington - Repetier

Help needed with Repetier and sli3er - 12 years ago

There is probably a very simple solution to this and I am sorry if this is littered all over the internet but after taking a few googles and scrolls through the forums I couldn't find the answer.. When I launch Repetier and connect to the printer everything is fine. When I go to manual controls I can control each of the axises and they seem to move at the correct scale. I can then set the home to

by paulharrington - Repetier

I am having a problem with the Stepper extruder - 13 years ago

Hi there, First of all Merry Christmas. I hope some of you can help me with this problem. I bought a prusa kit from taobao (the chinese ebay) and am all but complete. Tho I am having a problem working the extruder. The motor just seems to make a sound and doesn't actually turn the motor at all. when i connect this motor to a different connection on the board (say the X-axis) it works perfectly. I

by paulharrington - RAMPS Electronics

Re: Need help with my ramps board. No power - 14 years ago

Oh ok. That must be it so. Thank you. I feel kinda stupid. I am completely new to this. I got one or two of the motors working. Hopefully I will get the remainder of the job working. Thank you for your help

by paulharrington - RAMPS Electronics

Need help with my ramps board. No power - 14 years ago

Hi there, I have built a ramps 1.2 board and the brain is an arduino 1280. However the power doesn't seem to be working on it. I plug in the power into the ramps and when i press the power switch the green LED barely flickers. I got the ramps board soldered by an expert. i have the power source connected but nothing at all. I am a complete newbie and assuming there are people who have had the sam

by paulharrington - RAMPS Electronics