Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Hey guys I have been running my prusa i3 for some time now with slic3r, today I had to replace the heater on the extruder, did that and then fired it back up and when I went to run a project I noticed that the bed control in the manual functions section of slic3r was gon, no way to turn on the bed and when I turned on the extruder heater it would turn on then right back off. The project was showi
by
bobbyboy1962
-
Reprappers
mega 2650, I think I have done something wrong with the install, at least that's what I think as per the blue screen lol. Im just about to try the same print on my laptop, any help is greatly appreciated. So far I am impressed at the level of help with this hobby, there is no end of input from all you fellow 3d guys and gals, thanks
by
bobbyboy1962
-
Repetier
im having same problem here as well. Total newby and frustrated. I bought this from some one local to me in Toronto and it worked great for him. No such problem and he is trying to help me figure it out. I have it hooked to my desktop with the same usb cable he was using as well as all the parameters for repetier, slic3r, the only difference is the arduino software that I downloaded. The printer
by
bobbyboy1962
-
Repetier
well I hope this helps you with your x axis issue, mine ended up being the red wire on the 3 pin connector for the end stop on the board working its way out just enough to lose contact but not so far so as to be able to see it aat first. Pushed wire in and all is good , I am a happy man, I hope this helps
by
bobbyboy1962
-
Reprappers
I am having same problem here. Printer was working great yesterday now the x axis will only move in +, hit the home button and moves +, then resets home position to 0. the axis will go in the - direction in manual. eg; have x axis moved all the way to the home position and move to the +, 50mm then can move back in manual 50, no problem but move axis to +50 and hit x home button and the axis will
by
bobbyboy1962
-
Reprappers