Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
QuoteThe host gets developed on windows, which is why there are no linux binaries so far. Once finished i hope everthing works with mono as well. if so i will also publish a linux versionp with the curaengine also included.
Thanks for clearing up my confusion. I think I'll wait for the new Linux version of RepetierHost, hopefully showing an example of how to install in Linux, especially recent v
by
donde
-
Repetier
Right now I'm using Xubuntu 14.04 LTS. RepetierHost is 0.95F. About a week ago, I tried Mint 14. Mint worked, but only got the infamous error Generated G-code Not Found. I could clear error by just reducing the scale from 1 to 0.75. But, sometimes a model would fit fine with no error, and it was about the same size. But now in Xubuntu I can't even Configure in slic3r. The other tabs seem to work
by
donde
-
Repetier
Do you think my other problem in slic3r of no responce from clicking Configure is related? I would like to at least get that fixed, but not sure where to start.
by
donde
-
Repetier
This: Generated G-Code not found??? is so strange. It can come from so many unrelated reasons. I wish the Slic3r people would come up with a debugging routine.
I was able to clear my "Gererated G-Code Not Found by scaling down the object to 0,75 from 1. Then it would to finish slicing with no error box. Some people say maybe the raft
around the object was too big going outside the size of the pr
by
donde
-
Repetier
Decided to install Repetier 0.95f into my new install of Xubuntu 14.04 LTS. Got through all the steps but near the end, the Terminal showed a bunch of errors
indicating Perl version cannot be equal or greater than 5.14. Well, this Xubuntu is the latest and has Perl version 5.18.2. So that is not good.
Anyway Repetier launched OK and screen looked normal. However, I can't launch Configure in Slic
by
donde
-
Repetier