Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
I'll give it a go. Thanks.
by
tc1967uk
-
Repetier
Hi
Total 3D printing newbie here, apoloies in advance if my terminology is wrong.
I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier:
temp sensor defect marked defect
Errorrinter set into dry run mode until restart!
I've tried again today, and all 3 thermistors (and the spare) work fine,
by
tc1967uk
-
Reprappers
Hi
Total 3D printing newbie here, apoloies in advance if my terminology is wrong.
I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier:
temp sensor defect marked defect
Errorrinter set into dry run mode until restart!
I've tried again today, and all 3 thermistors (and the spare) work fine,
by
tc1967uk
-
Delta Machines
Hi
Total 3D printing newbie here, apoloies in advance if my terminology is wrong.
I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier:
temp sensor defect marked defect
Errorrinter set into dry run mode until restart!
I've tried again today, and all 3 thermistors (and the spare) work fine,
by
tc1967uk
-
Controllers
Hi
Total 3D printing newbie here, apoloies in advance if my terminology is wrong.
I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier:
temp sensor defect marked defect
Errorrinter set into dry run mode until restart!
I've tried again today, and all 3 thermistors (and the spare) work fine,
by
tc1967uk
-
RAMPS Electronics
Hi
Total 3D printing newbie here, apoloies in advance if my terminology is wrong.
I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier:
temp sensor defect marked defect
Errorrinter set into dry run mode until restart!
I've tried again today, and all 3 thermistors (and the spare) work fine,
by
tc1967uk
-
Repetier
Hi Dust
Total 3d printing newbie here, sorry. Had the thing over 8 months and never got it going.
I'm having the same problem: -
temp sensor defect marked defect / Errorrinter set into dry run mode until restart!
When you say unplug the thermistor, which bit is that, where in Repetier would it say 0ish, and where would I find the ADC pin?
Sorry to bombard you with questions.
by
tc1967uk
-
Firmware - mainstream and related support