Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
So if I'm using the A4988 drivers and i'm inputing 12V to the ramps a simple motor recives 12V per phase, then if I put two of them in series each one is going to recive 6 volts?
by
Mario Munoz
-
New Zealand RepRap User Group
Hola, soy nuevo en esto de las impresoras 3D y estoy por construir una, para la electronica voy a utilizar Arduino Mega con el firmware Marlin y las RAMPS 1.4, para los motores a pasos elegi los 17HS8401 (ya los ordene) segun lei los motores funcionan a 1.7A, mi problema es que no se como debo de hacer la conexion para el eje Z si quiero usar dos motores para este, en paralelo van a consumir mas
by
Mario Munoz
-
Mexico RepRap User Group
Hi there, i'm new to 3D printers and i'm about to build one, for the electronics I'm going to use Arduino Mega and RAMPS 1.4, for the motors I'll use 17HS4401 stepper motors(I've alredy ordered them), but for what I've read this motors work with 1.7A and i was wondering, how am I supossed to wire the Z axis if I want to use 2 motors for it? If i put them in parallel they will draw more current t
by
Mario Munoz
-
Mechanics
Hi there, i'm new to 3D printers and i'm about to build one, for the electronics I'm going to use Arduino Mega and RAMPS 1.4, for the motors I'll use 17HS4401 stepper motors(I've alredy ordered them), but for what I've read this motors work with 1.7A and i was wondering, how am I supossed to wire the Z axis if I want to use 2 motors for it? If i put them in parallel they will draw more current t
by
Mario Munoz
-
New Zealand RepRap User Group