hercek: Yes, I have big gashes in the buildtak from when it was grinding into the build plate. The behavior in the video is exactly what my printer was doing.by John707 - Delta Machines
I had this problem too - it was because I had the linear rails too high. If you watch it when it starts skipping, you will probably see one of the carriages hitting the bottom stop. I simply loosened all of the screws on the bottom stop and the rails, moved it down a bit, and tightened them up again. I left the top stop with the switch were it is, as the adjustment screw will prevent the carby John707 - Delta Machines
I have one of Eugene's heater's in my Tantillus, and so far I haven't had any problems. I have mostly been using 12V, but I have tried it at 14V for about 1/2 h without any problems.by John707 - Tantillus
Ok, I just finished the cube. It measures 39.58x39.82x39.84mm.by John707 - Tantillus
I wasn't so lucky with the corners: I am afraid to try and fully seat the rest of them. Is it better to print them in ABS instead of PLA?by John707 - Tantillus