Hi again crew! finally Foldarap 142 seems to be working but when it arrives to layer 20-25 de Z axis stops.... anyone with that kind of problem?? Z axis are working ok, i can move the hotend using manual controls in Repetier Host but when 142 is printing z movement stops after 20 layers... Thanks as always!!by nachetz - FoldaRap
You were right!! too much voltage on X&Y.... i think its solved! Quoteal44 Do you verify voltage on minitronics ? And how do you connect endstop ?by nachetz - FoldaRap
I connected endstops as Emmanuel said on the recent endstops update... I did not verify voltage... Z axis works perfect, and X & Y in one direction...by nachetz - FoldaRap
Hi!! finally y wired everything and uploaded the Marlin Foldarap2 Minitronic firmware. Everything seemed to be ok till y moved X axis and Y axis backwards: both motors got blocked... I mean: if i move along X axis it goes well in one direction but when i try to move the motor backward it gets blocked, a really strange noise begins and the temperature of the nema increases a lot!! The same happby nachetz - FoldaRap
Hi!! has anybody finished right the endstops wiring?? in that case... could you upload detail images of the wiring?! if someone has finished building a foldarap (one of the newest kits, number 105 to 150) it would be great to have photos of the connections... thats a quite poor parte of the building manual. Thanks!!by nachetz - FoldaRap
Hi Mattsi!! did it work to you wiring endstops on NC instead of NO? i see on bluilding manual photos both options... Regards! Quotemattsi Hi, Have a look at the electronic board chapter. It looks like your pic : For mine, I made it little different (for wiring acces). Have a look to the last pic here : (the one with the wiring) regardsby nachetz - FoldaRap
Thore are instructions for Foldarap 1, am i wrong? QuoteGlenn81 Bonjour, Are you following the right instructions ? I found that the right ones are here It looks to me as if you can just turn the whole thing round by 180° (but with the OPenedge logo still underneath) : then the mains power terminals will be in front of the power switch, and the power supply will be on the correct side. Glennby nachetz - FoldaRap
Great!! thanks for the link, great secuence of the process... really useful!! i think i'm going to do as you and move the power suplly for wiring acces thanks again! Quotemattsi Hi, Have a look at the electronic board chapter. It looks like your pic : For mine, I made it little different (for wiring acces). Have a look to the last pic here : (the one with the wiring) regardsby nachetz - FoldaRap
Hi again!! i'm founding quite a lot problems with the foldarap building manual: if I install the lasercut underplate as said on the manual the power supply is not aligned to the Y stepper (photo attached) .... It seems as the underplate was mirrored and i must turn it 180º and leave the Openedge logo inside the foldarap anyone else with this problem??by nachetz - FoldaRap
Thanks for answering so fast!! I was searching on the foldarap building manual and there was nothing about de Z endstop holder, thanks again!! About the belt clamp I meant this black piece I don't know if I need it on a Foldarap 2 or if I really received a mix of foldarap 1.1 / 2 .... boh?!by nachetz - FoldaRap
Hi!! need some help: i did not received belt-clamp part but i've received this one. Don't know where must i use it!!! thanks!by nachetz - FoldaRap