hello! iv'e hot jhead with out PTFE tube . and i have faced same problem jammed filament any body tell me is it compulsory jhead with PTFE tube ??by usman - Printing
hello! iv'e hot jhead with out PTFE tube . and i have faced same problem jammed filament any body tell me is it compulsory jhead with PTFE tube ??by usman - Mendel90
hello there ! can anybody tell me the sprinter firmware settings ? is it compulsory that the baud rate must be 25000? .can i upload firmware with 115400 baud rate ?by usman - Developers
hello there ! can anybody tell me the sprinter firmware settings ? is it compulsory that the baud rate must be 25000? .can i upload firmware with 115400 baud rate ?by usman - Reprappers
thanks buddy but actually i'm using these stepper motors on 'FULL" steps mode as required , so for full steps there is no need to connect any jumper .. okay if i connect those jumpers the thing that change will only change in steps of motor .by usman - Developers
hello! I've a problem in uploading firmware on ramps 1.4 .when i upload test code(which is given on reprap site ) in it then motors move properly .but when i upload firmware (sprinter , marlin ) on ramps then motor doesn't move properly . motors just create vibration but not mover .. i'm making prusa mendel iteration 2 . please help me out from this issue .by usman - Developers
i just merged ramps on arduino .. they are connected .. but when i upload firmware ..arduino shows port as hidden iconby usman - Developers
i have a problem with ramps 1.4 .. when i connect it with arduino mega 2560 then port error occurs . arduino shows port hidden .ponterface ,repitier host shows port connection error.. ponterface shows this error : Could not connect to COM4 at baudrate 250000: Serial error: could not open port COM4: The system cannot find the file specified. please help meby usman - Developers