Show all posts by user
Hi again, my second post.
The reprappro firmware wilki shows the menu items under file :- Upload config and Upload reprap.html but when I run Pronterface these items are missing.
I followed the link from the installation guide of my Ormerod and assumed that I had downloaded the correct reprappro version.
What I downloaded was RepRapPro-Printrun-Slic3r.zip and in that zip is pronterface.exe versio
by
appjaws1
-
Ormerod
Hi all,
This is my first post. I have printed my first items, the set up set. This print took about 3 hrs and I had to sit there and help the filament from the spool because the feeder had problems pulling the filament all the way from the spool on the control board around the back of the vertical assembly and wiring and then into the extruder feed mechanism. As the filament was being fed it se
by
appjaws1
-
Ormerod