So, I checked the SD card an you were right. I have since replaced the card but now when I try to home the axis they all don't move at the same time. In fact it starts with the x axis and it goes in the oppsite direction.by Tech-Masterz - Crowdfunding Projects Announcements
You might have a faulty SD card, I recommend you find a new microSD card, and try following the instructions at : Thanks I'll try that and let you know what happened. Any other suggestions about the issues?by Tech-Masterz - Crowdfunding Projects Announcements
So, I just got my board about two weeks ago and I having a world of trouble and its three fold. The company has yet to respond to my emails and I am so lost with what I am doing. Firstly, i have installed the drivers needed to connect the board to the computer however it will not show the SD plugged into in when connected to the computer. It only shows its on a comp port as smoothieboard. My sby Tech-Masterz - Crowdfunding Projects Announcements
I know I'm a little late, but you can buy the Re-arm board here: Re-arm boardby Tech-Masterz - Crowdfunding Projects Announcements
Hey, wow that is a lot of info. Anyway, a good way to get rid of the bumps is by disconnecting the bigger smart graphics lcd from the printer and use the computer??? I like using the LCD is there a way to keep it and have smooth prints. My mini kossel set up is as follows: ramps 1.4+ arduino mega, EXTRA LARGE FULL GRAPHICS SMART CONTROLLER , 15amp power supply, using cura as the slicer. However,by Tech-Masterz - Printing
My printer is the mini kossel, and now its dipping on opposite side of the print bed but the middle is just fine. Know of any solutions?by Tech-Masterz - General
I have the ramps 1.3 though.by Tech-Masterz - General
so, how would i do that??? What about the other issue?by Tech-Masterz - General
Ok, so i ended up geting a 15amp power supply. Now pretty much everything is in working order. However, I have the following problems. 1. My autoleveler probe will not extend to the close enough to the belt to deploy it's self. 2. My smart lcd screen will not light up by just having my power cord pluged in. Please help.by Tech-Masterz - General
You know what I am going to get a 20 amp power supply instead. I did more research and I found that I could get away with only 12v 20 amp power supply.by Tech-Masterz - General
Do you know of any places or links that would have like a 20-25A power supply?by Tech-Masterz - General
Thanks for your help it was the wiring and now everything says ready to go. How ever now it wont opperate the G28 to hone the 3 axis and its not because of the endstops. However, I think it might be the current that you mentioned I have 12A 5A 60W power supply. Iread other forums and they tell me that I need at least a 20A power supply so I going to try that and see where that leads me.by Tech-Masterz - General
I seen this error countless times and I just basically finished making my mini kossel. I dont get it, the extruder is not turned off. I made sure to connect the extruder in the right terminals even the thermistor is in right but in pronterface and in curai get the same message. Someone please help so I can get this printer working because this error wont allow me to do the G29 code to auto levelby Tech-Masterz - General