Thanks for the tip Dave. I tried to check what you said but when I clicked on 'Config' in Repetier Host, the button for 'Firmware EEPROM configuration' was "dark" (unclickable). I think this is because I am using Sprinter firmware instead of Repetier Firmware. I actually realized that I accidentally said that I was using Repetier Firmware in my initial post. That was a mistake, I am sorry aboutby RP Iron Man - Slic3r
First of all, thanks to everyone for their input. @Alagi: I have tried manually retracting filament using the buttons and it works perfectly. It only fails during prints. @Sublime: I am using Slic3r Version 0.9.2. @Cefiar: I am not sure what hot end. It is the standard hot end for Wade's Extruder. 0.34mm nozzle. I can retract manually using the buttons without any issues so I doubt that wouldby RP Iron Man - Slic3r
Hello World! This is my first post on the RepRap forums I have finally finished setting up my Prusa Mendel printer, but I have been having trouble perfecting my prints due to an issue with my extruder retraction. The problem is that during non-print moves the extruder is not retracting filament. However, after the non-print move is completed, the extruder extrudes an extra length of filament tby RP Iron Man - Printing
Hello World! This is my first post on the RepRap forums I have finally finished setting up my Prusa Mendel printer, but I have been having trouble perfecting my prints due to an issue with my extruder retraction. The problem is that during non-print moves the extruder is not retracting filament. However, after the non-print move is completed, the extruder extrudes an extra length of filament tby RP Iron Man - Slic3r