The processor was indeed correctly installed and the power was ok. The problem was the USB cable. There where no datawire connection in the cable , only power connection. I think that this cable was an old power cable from a cellphone ? So now we can start again. Thanks for the help. Regardsby stibo01 - Ormerod
The board isn't visible in the device manager. The power is ok. All leds are ok. Perhaps there is still a fault in the board or is this only a software problem ?by stibo01 - Ormerod
Hi,-- my duet board was blown up a few years ago ( arm processor was very hot ). Last week I replaced the arm processor.(arm3x8e ) Who can help me to restart the duet board? How can I place the boot in the processor and wich boot ? thanks in advance..by stibo01 - Ormerod
Hi, the usb connection with the duetboard is broken. The led D1 lit continue , even without usb connector. The reset button doesn't work , and the ARM processor is very warm , too warm . Is it possible to replace this board under warranty ? regards ,by stibo01 - Ormerod
@ Ian When I disconnect the sensors , everything works like expected in the building instructions ( -273 ) It'sthe same with the ATX PSU ( with JP9 jumper ) The solder quality is poor , but should work. Solution : Just like dc42 mentioned : The temperature measurements are not displayed when the sensors are working , only if they are disconnected I wenby stibo01 - Ormerod
Hi all , I have completed the assembly of my Ormerod. The assembly went pretty well. I do have a problem with both temperature sensors. When the printer communicates with the arduino IDE : "RepRapFirmware is up and running" , but nothing about the temperature measurements. If I disconnect the sensors , everything works well, The heated bed thermistor must be 10K ( measured : ok ) The hot enby stibo01 - Ormerod