Hello Antlvk My Duet died i the same way. I my case RRP replaced my duet. You can buye new bord at , But the board has another kind of terminals. janby XB70 - Ormerod
Hi Dc42 Kit arrived today, looks excellent, thanks. Now i just need to chance my defect extruder stepper. Nice worke for the weekend janby XB70 - Ormerod
Hi Dave Thank You for doing this, put me down for two and a coupel of bed support. janby XB70 - Ormerod
Thanks for all your good suggestions. I try my way on old circuit @epninety. I live in Denmark. @Chaisaeng. I have ordre "SMD1 REMOVAL KIT, SMD" from chip quik janby XB70 - Ormerod
Hello everybody I have burned the extruder stepper controler and will now replace it with one I bought. But I do not know how to get the old of the PCB . Are there any good suggestions janby XB70 - Ormerod
May be you could use a Raspberry Pi as a webserver it is cheap an uses only a few watt of 5V janby XB70 - Ormerod
I Found this Information about metric threaded rod Jy oc hx you are right on the nose, about M5 pitch is 0.800 and M6 pitch is 1.000 So now I will make an new Z-to-X axis thing, to take the new coupling-nut. I will post the stl file later. That will take a while, I am waiting for a new Duet from RepRapPro. janby XB70 - Ormerod
intelligent hobbies intelligent peopleby XB70 - Ormerod
My M5 threaded rod has been worn and I have acquired a M5 A4 and M6 A4 with a long/large nut (40 mm) for the M6, The nut is usually used it to combine the rods. The problem now is how do I measure the rise in an M5 and M6 so I can regulate Y-axis or is it a bad idea to replace the M5 whith a M6 rod. janby XB70 - Ormerod
Hi everybody Today i recived a email from reprappro where they promist to replace my duet and ir-senser. It is a problem white the heat spreader is cam be up side down an then ther is a connection to the header. Everybody please check that you hedt spreader dos not connet to the power of the headerplate. janby XB70 - Ormerod
Hi Kim Brown Water cooling : look here I want oneby XB70 - Ormerod
Watch the clips on the side, they can short-circuit the IR sensor and then it ended of the Duet, It has no protection from this kind of accident. My Duet just diedby XB70 - Ormerod
Hi dc42 Thank you for all your work and god answers. Can I order a kit 5 please Janby XB70 - Ormerod
I would like a fully populated board as well Janby XB70 - Ormerod
Hello I have completet a built of a Ormerod 3d printer, not many problems there and are now traying to get the software runing. I have updatet the firmware ( after 3 times ) it is the firmware from 2014-01-16. The M115 command report correctly, but when i try the M503 I get an error can't open 0:/sys/config...... I have used the 2gbyte sd-card deliveret, and a 1 gbyte from my phone, bothby XB70 - Ormerod