One thing that the RRP web interface has that I thought was important was password protection. I would like to see that implemented sometime. Mine is on a more of an open network and I worry.by Silver - Ormerod
That already exists M80: ATX Power On Example: M80 Turns on the ATX power supply from standby mode to fully operational mode. No-op on electronics without standby mode. Note: some firmwares, like Teacup, handle power on/off automatically, so this is redundant there. Also, see RAMPS wiring for ATX on/off M81: ATX Power Off Example: M81 Turns off the ATX power supply. Counterpart to M80.by Silver - Ormerod
I got mine yesterday and I just have it all fitted. This is a very nice upgrade. I have easily manually leveled my bed now. This thing has made the bed nice and solid.by Silver - Ormerod
I print right to the glass. I apply a fine mist of hairspray on the glass and very tall pieces with tiny bases stick so well they cannot be pulled off even after bed cools to room temp. Pop the glass with part in the freezer for a min or two and it falls off as if magic. Once in a while, I clean off the excess hairspray with a little acetone on a paper towel. I print with the bed temp at 65by Silver - Ormerod
I just print right on the glass and give it a light mist with hairspray to help. I can print really tall parts with tiny base and still cannot pull the parts off after the print. After the printed reaches about room temp, I just pop the glass in the freezer for a minute or so and it comes off as by magic. Acetone cleans the excess hairspray off of the glass easily.by Silver - Ormerod
I would be interested in one as well. Paypal is fine plus shipping to the US if possible.by Silver - Ormerod
It is certainly not your bed temp. I print at 70C with a Huxley on glass and have no problems. In my experience bottom of prints getting all fat and melted looking is from the extruder not starting at the correct bed height or extruding too much at the start of the print. I was doing this for a while to really get a good bond but it was really messing up screw holes and such. From your picturby Silver - Ormerod