I have just updated the firmware to 1.16RC2 however after I did this I no longer get extruder heater temperatures on the web interface I only see the bed heater What happened. When I revert back to 1.15e I can see the extruder heaterby percar - Duet
Is there a Gcode and Mcode command list for the latest firmware around someplaceby percar - Duet
is it possible to add the possibility of driving 2 stepper motors in sync for example to use 2 motors on Z axis I have requirements to run 2 x axis and 2 z axis motors. I do not want to run them in series due to the amperage required I currently have an azteg X3 pro but i want to replace it with my duet I would appreciate any helpby percar - Duet
Hi I have been following the new build instructions for Duet Firmware following the instructions embedded in the firmware zip The issues i have been having are as follows I installed eclipse without issue I started eclipse and created workspace C:/Eclipse/Firmware I closed eclipse I downloaded and unzipped RepRapFirmware-dev and placed into C:/Eclipse/Firmware then renamed to RepRapFirmware I dby percar - Ormerod
I have found a pin map for Arduino due (https://www.arduino.cc/en/Hacking/PinMappingSAM3X however as you know there are a number of pins that were not defined by Arduino Is there a pin map the defines the additional pins. 93-126 (X1 and up)by percar - Firmware - mainstream and related support
I have a custom 3d printer that uses 2 x drives and 2 z drives I have a duet controller with expansion Is it possible to mirror the x stepper movements to one of the drivers on the expansion board and mirror the z axis stepper movements to one on the expansion board I know it is possible to wire 2 stepper motors in parallel or series but this is not an option that I want to use If you could put mby percar - Firmware - mainstream and related support
just a comment There are many servo drives out on the market that work on step and direction inputs the same as stepper drivers. just a thoughtby percar - Controllers