So, for the update, everything works perfectly and it's beautiful ! Thanks for the help it's a 12Vby golfox2 - General
@govahnator : I just received my hotbed 12v and i'll be assembling it asap, but thanks for the offer, if this one doesn't work, i'll contact you for the laying bed you haveby golfox2 - General
Hey guys, I've got a homebuilt RepRap Marlin flavoured printer, I'm looking for a new hotbed + magnetic plate that levels manually (i've got the screws and springs already), to change that inductive auto level that's never working. Any recommandations please ? My actual bed is 220x220mm and 12v for the heating plate. (I can go 240x240 if really needed). Ideally with chamfered screw holes alreadyby golfox2 - General
Hi guys, I have a little problem, since a few months, my homemade GCode file for easy filament change won't work anymore. I don't understand why but something broke somewhere. My file does homing, then retract slowly for a few mm, then retracts quicker, waits 5 seconds, and then takes back the new filament inside, slowly, quickly, and again slowly when it comes to the extruder. I don't know whaby golfox2 - Smart_Rap
hey, up =) Do you guys think something exists to set an offset for each probe point here in the configuration.h of the software ? I'm in linear auto bed levelingby golfox2 - CoreXY Machines
Do you guys think something exists to set an offset for each probe point here in the configuration.h of the software ? I'm in linear auto bed leveling #if ENABLED(AUTO_BED_LEVELING_LINEAR) || ENABLED(AUTO_BED_LEVELING_BILINEAR) // Set the number of grid points per dimension. #define GRID_MAX_POINTS_X 2 #define GRID_MAX_POINTS_Y GRID_MAX_POINTS_X // Set the boundaries for probing (wherby golfox2 - CoreXY Machines
The thing I don't understand is that it was working a few weeks ago, and suddenly, stopped working. In fact, my hot-end fixation just melted after the fan didn't start one time. So I thougt that was the issue, and I replaced the defective parts. But no result. Yes I also tried to rotate 90, 180, 270° de glass plate, same, no improvement.by golfox2 - CoreXY Machines
Hi, sorry I didn't precise, it probes front-left, then front-right, then back-right, then back-left. 4 points in total. QuoteDoes it then make the front too close to the bed? It does not change anything, if I de-level, in any way, the printer still compensates, but will do the same problem even with a maximum tilt angle. QuoteThe cable guide looks pretty rigid. Does the inductive probe tilt, whby golfox2 - CoreXY Machines
Hi everyone, I have an issue with my SmartCore (RepRap, Marlin) 3D printer. It has the G29 feature to level the bed according to a probe, but it does not compensate for what it should at the back of the plate. - I tried to over "de-level" the bed (like 2cm and it still compensates so the G29 command works) but in any case, the back is too close to the head, and the front is fine. - I replaced evby golfox2 - Mechanics
Hi everyone, I have an issue with my SmartCore (RepRap, Marlin) 3D printer. It has the G29 feature to level the bed according to a probe, but it does not compensate for what it should at the back of the plate. - I tried to over "de-level" the bed (like 2cm and it still compensates so the G29 command works) but in any case, the back is too close to the head, and the front is fine. - I replaced evby golfox2 - CoreXY Machines