I had the jumper on for XST and YST. I removed them and it started working. Although now I'm using sensorless homing and not using the X and Y endstops.by bcrazycramer - Firmware - mainstream and related support
I'm using an SKR 1.3 with Marlin 2.0.X. I'm trying to get my optical sensors working on my Hypercube Evolution. I'm only using Min endstops. I've connected S Pin to V pin sent a M119 and no change I've connected S Pin to G pin sent a M119 and no change //============================== Endstop Settings =========================== //===============================================================by bcrazycramer - Firmware - mainstream and related support
I'm not sure why I mentioned the 20 tooth... After I figured out 1 revolution was 8mm, I found on this forum someone else getting help with this issue. Thank you for the help.by bcrazycramer - CoreXY Machines
400 steps per mm seems to be the correct number.by bcrazycramer - CoreXY Machines
Quotethe_digital_dentist How many steps per rev in the Z motor(s)? 20 tooth What is the screw lead? T8 Is there and gear/belt reduction? Noby bcrazycramer - CoreXY Machines
I have my Z set to 1/32 stepping and 5120 steps per mm. However when I move 1mm in Repetier host my Z axis moves 6.33 mm.by bcrazycramer - CoreXY Machines
Thank you for the assistance. I remove all the inverting stuff from Repetier host and from the config and now I can home X and Y.by bcrazycramer - CoreXY Machines
I now have A motor plugged into X and B motor plugged into Y. Should I need to make changes to Repetier host to invert direction controls for X-Axis, Y-Axis, Z-Axis and Flip X and Y?by bcrazycramer - CoreXY Machines
Quotethe_digital_dentist Which XY motor is plugged into which driver on the controller? I’m using an Azteeg X5 Mini WiFi with SD2224 drivers. Is that what you are looking for?by bcrazycramer - CoreXY Machines
I'm having trouble with homing endstops. I'm using optical endstops. I can move the carriage around no problem. It moves in the correct direction. When I move the carriage over and trigger X and Y it shows: X_min:1 Y_min:1 Z_min:1 pins- (XL)P1.24:1 (YL)P1.26:1 (ZL)P1.28:1 It appears that homing Y is working. When I try to home X it moves to the right instead of moving to the left where the eby bcrazycramer - CoreXY Machines