I added BL Touch to CR10S. I used the latest firmware, 2.0.9.1 and going back to pre version 2. When I print a part the Z position on the display says it is at .8mm. It stays there until the actual height exceeds this value, then all is okay. Also the Z axis does not move for the first couple of layers, until next layer exceeds .8mm. I have tried many many things to no avail. Has anyone elsby StarkFlyer - CoreXY Machines
Vikor, Thanks for your reply. With the Z shafts removed from the motors so there was no load on them I could not feel or see any type of movement when the Z axis was suppose to step. Not even a fraction of movement. I can manually position Z axis using microstepping along with using a dial indicator to measure movement. All seems okay when doing this. Dickby StarkFlyer - Firmware - Marlin
I have a CR10S with BL Touch added to it. I have been having intermittent hot end jamming problems. I printed a cube and found out Z was not stepping for the first 3 layers. It would start stepping at the start of the 4th layer. The cube is very simple: .2mm layer heights, 100% infill. I disconnected the Z shafts from the stepper motors and propped the Z up and ran the print. This way I could chby StarkFlyer - Firmware - Marlin
I am trying to compile 2.0.7.1 using Arduino IDE verision 1.8.13 and I get the following error. In file included from c:\users\richar~1\appdata\local\temp\arduino_build_580165\sketch\src\inc\marlinconfig.h:31:0, from sketch\src\HAL\AVR\HAL.cpp:24: c:\users\richar~1\appdata\local\temp\arduino_build_580165\sketch\src\hal\hal.h:22:10: fatal error: ../shared/Marduino.h: No such fby StarkFlyer - Printing