Hi all I have an Ender 3 with an SKR Mini E3 v2 and while testing this new pi clone, it seems I have managed to fry the USB port. I'm using an old 12864 console, so it seems there's a serial port in the TFT plug that should be usable with octoprint on a pi. Any idea how to configure this serial port with marlin? thanks royby royk - Firmware - Marlin
I guess you found out by now, but M302 S0 ; disable all extrusion checking Just borrowing this thread, is there a way to re-enable PREVENT_LENGTHY_EXTRUDE after the above command? I tried M302 S170 and re-enabled PREVENT_COLD_EXTRUSION, but not PREVENT_LENGTHY_EXTRUDEby royk - CoreXY Machines
Hi I've compiled latest Marlin, 2.0.7.2, to run on my ender 3 with an SKR E3 mini v2. This works well, but I just tried to enable UBL, and things are starting to show up not as nice as before. I first had some issues with the probe (original bltouch) but my fault. Then, after probing the bed, a map was created and I ran G28, G29 L1 and G29 J. At this point, the probing failed. Please see for thby royk - Firmware - Marlin