Sublime- spot on. Solved the problem nice quick and easy even though I did try this before I got the result needed. Waitaki I guess this method would also work but I don't want to mess around too much with the firmware if I can help it! Thanks guys. Just resolved my Y axis as well. Next I need to figure out why the extruder stepper motor is dead/unresponsiveby leboy070489 - Reprappers
Hi thanks for the reply- I did after another 30 mins of googling find another manual but the build aspect is fine, its solid and sturdy. I really think there is some calibration/software setup issue for which the instructions haven't been that great/or specific Ok- my firmware came pre-loaded. Marlin firmware using RAPRAP V1.4 on an Arduino Mega. Ive been able to test all the end stop switchesby leboy070489 - Reprappers
Hello all :-) I recently ordered a kit from a supplier as recommended by a friend. The kit is a reprap i3, with a 1.4 Ramps board with the firmware already installed so I was told, 1 extruder and hot bed all powered by a ATX power supply. Ive built the printer and all seems fine on that front however I am just seeing funny performance. If I put a video up would someone be willing to help me outby leboy070489 - Reprappers