I did not get it to work. Wired everything up but nothing happened, it's like there's ground missing. I tested many time, swapped cables and so on. This TB is weird compared to other TB drivers, but it works well with CNC machine controller. Good thing is that I did not fried anything so I just decided to use a4988 stepsticks for now.by norkator - Reprappers
Might be, all this is poorly documented. Where's that microsecond setting exactly is on Marlin? No need to respond, I sort that out after testing tb with ramps (tomorrow)by norkator - Reprappers
Thanks Frans for that link. Here's picture of my TB6600, there's no + and - signal inputs like other tbs have, only - inputs and that one +5v. I get my ramps on Monday so it is either going to work or it's going to smoke. That roboforum.ru link seems to be very helpful. Those - signal inputs all goes to three different components before going to Toshiba driver and some chinese instructions thaby norkator - Reprappers
Thank you for your reply, I keep this in my mind. I'm going to dig this problem deep before testing, last thing I want to do is to fry ramps, arduino or stepper driver. If there's correct answers before I get my ramps, I'll make tests and post results here. If I got it working I'll post correct wiring method here.by norkator - Reprappers
Hey, I need some help with connecting TB6600 stepper driver into Ramps 1.4 board. TB6600 signal inputs are following and these are taken from the picture above. ENA- / EN- DIR- / CW- PUL- / CLK- +5v / +5v Enable: ENA- goes Ramps 1.4 stepper driver pin EN ? Direction: DIR- goes to DIR ? So where PUL- and +5v goes? Here's the picture of this TB6600 Thank you for your answers in advance!by norkator - Reprappers