Show all posts by user
People building or using RepRaps.
Re: Commisioning problem Ormerod V2 - 10 years ago
Hi Meanwhile, my buddy put the Ormerod and a Notebook into a huge box .. and gave it to me .. The good news so far, thanks to Chris (thank you very much), I upgraded the firmware, as per his suggestion. The good news is, I could for the first time move the 3 axles (X/Y/Z) using the Surface indicating the 3 Axles (and pressing the 'arrows') .. even the bed heated up. I guess, the main problem hby Pelagiman - Reprappers
Re: Commisioning problem Ormerod V2 - 10 years ago
Hello Chris Thank you very much for your support. I will translate your suggestions to my buddy. After he has followed your suggestions, I will write about the outcome, to share the learnings with other people here, that might face the same issue. Thanks again, Best Regards, Oliverby Pelagiman - Reprappers
Commisioning problem Ormerod V2 - 10 years ago
Hi I write on the behalf of a buddy of mine, who bought a RepRapPro Ormerod V2 3D-Printer. He followed the checklist, listing up 14 point for commisioning( cabling, LED check etc.) of the device and confirmed, that the basic installation and settings were ok. Please find enclosed, the problems he faced, when trying to run the 3D-printer: Currrent state of his 3D Printer: 12.06.2016, V.1.0.0 Bby Pelagiman - Reprappers