That idea would need lots of memory to hold the data and would take longer. It'll take long to generate and will slow down the print with compensation needed at every step that the stepper makes. Another problem is that practically all sensor probes need to not be triggered at the start of a probe.by Stephen6309 - Firmware - Marlin
Use a seperate 5v power supply for the BLTouch. When I used a BLTouch on a RAMPS, I used a 7805 to supply power to it. I didn't use a capacitor, since the 7805 worked fine by itself.by Stephen6309 - RAMPS Electronics
An AC heater with a SSR will be faster on the heatup. I use 2 200x300 keenovo heaters on my 300x400 bed heating 1/4" MIC6.by Stephen6309 - General
Who ever designed the board you put on the Due, didn't design the board correctly.by Stephen6309 - Developers
You could remove the top plastic piece/bearing and see if the print improves. If it does, the leadscrew is bent, it doesn't take much of a bend to cause problems.by Stephen6309 - Reprappers
You should post this in If you're using the 2015.03-2 version, try the development snapshot version.by Stephen6309 - OpenSCAD
What is the error? if a comunication error, use a different cable or usb port.by Stephen6309 - RAMPS Electronics
For Pololu drivers:by Stephen6309 - Firmware - Marlin
The start gcode in your slicer that sets the temperatures.by Stephen6309 - Firmware - mainstream and related support
A genuine e3dv5 3mm has no PTFE. I have a 3mm and a couple of 1.75mm, PLA works fine in them.by Stephen6309 - Printing
It looks you need to use a parts cooling fan.by Stephen6309 - Reprappers
When I used a ramps, I just soldered a two pin header on the bottom, sticking out the side of the reset button connections underneath to connect another one else where.by Stephen6309 - Safety & Best Practices
From your description, the micro stepping is set wrong. Check for bad solder joints on the new stepstick.by Stephen6309 - General
Leadscrews by themselves will allow the Z to wobble, they're not that stiff.by Stephen6309 - CoreXY Machines
LEFT_PROBE_BED_POSITION is outside the probe region means that the x min probe position is less than X0. Did you remember to add the x offset to the selected value?by Stephen6309 - Firmware - Marlin