Not to bring back an old post but we are converting one of our high school's CubeX Duo to Reprap and have replaced the PSU to 12v and added a BIQU-Mega2560 and Ramps 1.6. We have tried several times to flash Marlin to the board and it compiles but then... nothing. Any help with the firmware would be appreciated. I can provide more info if needed. thanks steveby Jeepsteve - Reprappers
We are running this setup on our nearly gutted and rebuilt Cubex Duo and we have been unable to flash Marlin successfully. The power works to the Mega and the Ramps 1.6. The LCD lights up and when we upload Marlin, it says it compiles just fine. However, we get nothing that is obvious. Several red LEDs are lite on the board now, not sure what any of it means. The same Marlin setup is on our FT5by Jeepsteve - Firmware - Marlin
we thought it was weird. the package advertised on Amazon was a 1.4 and looked right. oh well. thanksby Jeepsteve - Reprappers
New to the 3D world but we own a Folgertech and are rebuilding a CubeX Pro Duo for my sons high school. The printer had died and it is one of three that are too cost prohibitive to keep as they are. We are converting the carcass over to a RepRap set up after gutting the original. its going well and fairly simple so far. However, we purchased all new electronics from Amazon. This is what we purchaby Jeepsteve - Reprappers