Show all posts by user
People building or using RepRaps.
Re: Screen offset issue - Reprap discount full graphic smart controller - 7 years ago
Quotefrits1956 Problem not yet solved? Is this problem with marlin software, version RC7? Try this: Find U8GLIB_ST7920_128X64_RRD u8g(0); you should find it in tab ultralcd_impl_DOGM.h make backup (type // in front) and type on new line U8GLIB_ST7920_128X64_1X u8g(23,17,16); Compile and Upload Worked perfectly, thank you so muchby _matt_ - Reprappers
Re: Screen offset issue - Reprap discount full graphic smart controller - 7 years ago
I think you may be right imqqmi, I'll source a different driver and give that a go when I get some free time. Thank you everyone for your suggestions, I'll continue to check here if you have any others and I'll be sure to post the fix if I find oneby _matt_ - Reprappers
Re: Screen offset issue - Reprap discount full graphic smart controller - 7 years ago
Just tried backing off the screws, no improvement Thanks for the suggestion thoughby _matt_ - Reprappers
Screen offset issue - Reprap discount full graphic smart controller - 7 years ago
I've been having an issue with my screen on my Reprap, it's more of an annoyance than an issue really. After a few minutes of operation the screen will kinda shift over to the left, with the cut off part wrapping around to the right. I've attached a picture of this. I have no idea what is causing it, fairly sure it's not marlin as I've used a few different versions with the same result. My guesby _matt_ - Reprappers