My bltouch on my kossel doesn't work. It looks like it is working, but will never trigger. M43S does not detect a trigger (https://gyazo.com/46704223aa13e1f190995588cc585d81) When i disconnect the bltouch, it says triggered, like it should be. And i read that ENDSTOP_INTERRUPTS_FEATURE sometimes fixes this, but i can't enable it because im using tmc2208 (Select hardware UART for TMC2208 to use boby StealthNinja1O1 - General
Commenting out #define VALIDATE_HOMING_ENDSTOPS worked, but now it just resets after homing. it also doesn't home the axises at the same time. the tmc drivers are connected and soldered correctly. (https://gyazo.com/00b8ef17a5e8bb476e48195857edcefb) do you know how to make them home at the same time and stop it restarting?by StealthNinja1O1 - Reprappers
Ok, I'll try that. And it doesn't move at all Thanksby StealthNinja1O1 - Reprappers
Open, and they say triggered when I trigger them manuallyby StealthNinja1O1 - Reprappers
That's like exactly what I did. Geeetech doesn't supply a Delta config, so I began with generic Delta example. Homing ect looks like it's set like it should be, so I really don't know the problem.by StealthNinja1O1 - Reprappers
what I mean with halted, is that marlin halts (just like when you have a thermal runaway), thats also what I am using. Marlin 2.0. marlin is supported, and i think the steppers are wired correctly since the extruder does work normaly. The error comes up immediately when i try to home, click and instantly have the error. the motors do not make any noise at all, and when i use g112 (tmc debug) theyby StealthNinja1O1 - Reprappers
I already resoldered the end stops so they are all the same mode, and working. But when I try to home, it just halts instantly without any movement happening. Moving the axises without homing doesn't do anything as well, but no error then. I'm currently trying to install klipper on it to see if it's the firmware, but had no succes making that work so far.by StealthNinja1O1 - Reprappers
Hello I am looking for someone who can figure out why my custom kossel won't home. Every time I try to move a axis (extruder does work btw and min-temp is set to 0 for testing) it just halts. It says, Homing failed, Printer halted, Please reset. I am using a bigtreetech SKR V1.3, and am compiling it with vscode and PIO Home. 2 of my endstops are in No, and the other one in NC, Maybe that helps.by StealthNinja1O1 - Reprappers