Thanks for the input. It was the zipped format of U8glib.rar library file (and location) that hung me up. Some configuration troubles still, as for the new brain "It's Alive!"by instmkr - Firmware - Marlin
It is a standard LCD with push/rotary input and SD card. Pretty sure part of my trouble is the library. The vendor supplied a compressed file U8glib.rar and I can't seem to grasp what to do with it. All responses appreciated.by instmkr - Firmware - Marlin
The display is LCD12864 which I don't see in configure.h Is the SSD1306 OLED compatable? "#define U8GLIB_SSD1306" is very similar to recommended driver.by instmkr - Firmware - Marlin
So looking at the display section of configuration.h, when I do find the correct display/adapter do I just delete the "//"?by instmkr - Firmware - Marlin
Hello Replacing dead solidoodle2 electronics with ramps 1.4 and mega2560. Arduino compiled and uploaded Marlin successfully but lcd display is only backlit. Board "connected" with Repetier-host but no manual control of printer. Any ideas where to start?. Thanksby instmkr - Firmware - Marlin
Hello My ancient solidoodle2 has frozen up after 10's of kilos of filament. At power up XY steppers lock (carriage not free) for a few seconds then cutout, freeing the carriage. Also at same time, the extruder stepper fan, normally on, stays off. Fan tested OK. Any ideas as to where to start? Thanksby instmkr - Printing
Quotedmould The solid infill is done in order to maintain the correct number of top layers - in a pyramid an area inboard of the perimeter of one layer is effectively the first top layer of a higher layer (imagine drilling vertically down from a point halfway down the side of the pyramid - the drill point gets further away from the edge as you go down through the layers, but nevertheless should hby instmkr - Slic3r
Is there a way to prevent or minimize the extra solid infill illustrated below? Thanksby instmkr - Slic3r