Im in the testing stages now of my RepRap build, using Ramps 1.4 with Marlin and a 12864 Controller. Does anyone have or know of an instructions set or navigation tree for this bit of kit.by wetsparks - General
Just to say, I am just completing the build of me new printer and I brought a twin extruder from ebay that had these nozzles with the thermocouples in. I carefully peeled off the red lump in one piece, comes off quite easily. There is then a small wrap of silver foil and a twisted wire wrap you have to undo that holds all the cables in one bunch. After that the thermocouple removes without troubby wetsparks - Reprappers
Hi all, just finishing the build of my RepRap-esck style printer. Got to the point of printing a test cube 30 mm square. The Z height ended up at 30.03 mm so well pleased with that, but both the X and Y came out at 30.74. These drives are 2 mm pitch belt drives with 20 tooth sprockets and 200 (1.8 degree) motors and the driver at 1/32, the final figure in Marlin is 160 on these axis. What to do nby wetsparks - Reprappers
Do you have one of those mirrored glass plates on top? I did and the bugger shorted out the heat bed contacts. Fried me 1.4 boardby wetsparks - General