Show all posts by user
http://reprap.org/wiki/Prusa_i3
Re: My Replikeo Prusa i3 Rework Build - 10 years ago
hello, now everything works ok ---i am just before my first printby bc - Prusa i3 and variants
Re: My Replikeo Prusa i3 Rework Build - 10 years ago
Hello, I have now got it working, including bed levelling, except for the extruder motor that avoids controlling via the repetier host.Could anybody help? Thank you.by bc - Prusa i3 and variants
Re: My Replikeo Prusa i3 Rework Build - 10 years ago
This report would have more information with "Show verbose output during compilation" enabled in File > Preferences. Arduino: 1.0.6 (Windows 7), Board: "Arduino Mega 2560 or Mega ADK" core.a(main.cpp.o): In function `main': C:\Program Files (x86)\Arduino\hardware\arduino\cores\arduino/main.cpp:34: undefined reference to `setup' C:\Program Files (x86)\Arduino\hardware\arduino\cores\arduino/by bc - Prusa i3 and variants
Re: My Replikeo Prusa i3 Rework Build - 10 years ago
Hello tomleeds, When i try to upload sketch it goes though the motion but ends up with fault at compilationby bc - Prusa i3 and variants
Re: My Replikeo Prusa i3 Rework Build - 10 years ago
Hello, Correction to my last mail.There is a steady red light on the ardino 2560 board and a blinking red light on the ramps 1.4 board when either power is applied or my pc is active.by bc - Prusa i3 and variants
Re: My Replikeo Prusa i3 Rework Build - 10 years ago
Hello, I have put the kit together and double checked the wiring but run into problems with the sw. I downloaded ardino and marlin and prontoface and they are now installed on my pc. There is a red light blinking on the ardino board.When I try to upload ardino firmware it goes through the motions but end up unsuccessful. I am not a programmer so any help for dummies appreciated.by bc - Prusa i3 and variants
Re: My Replikeo Prusa i3 Rework Build - 10 years ago
Hey folks, I have joined and have the following problems. 1. The M5 nut that is responsible for the movement in z acsis together with the threaded 5 mm rod will not stay put on its mark.I dont understand the expression " thread the threaded rod". 2. The y axis belt causes some problems.How is it terminated on the y axis sled? Hope somebody can help me.by bc - Prusa i3 and variants
ebeltoft og omegn - 10 years ago
hej Jeg har lige bestilt en replikeo i3 reworked og vil gerne i forbindelse med reprappere. Vhbcby bc - Denmark RepRap User Group