QuoteWaltermixx Howdy Folks, I'm back... I've been using my makerbot mostly for printing since i got it. I only used my Folgertech when I needed someting done in ABS... well yesterday my makerbot Replicator 2 suffered a pretty bad jam, and i was unable to get consistant results from it without it jamming... new parts on order. In the mean time I grabbed my Folgertech Prusa I3 printer, reby mickey - Prusa i3 and variants
Hi I have this calibration stl which is 10mm X 10mm with inside 5mm X 5mm empty square and as long as I try I cant get my Folger tech printer to go above this quality. what am I doing wrong? according to the pic what need to be fixed with the marlin conf file?(the x mark on the print is the front side) I also attach what I think is relevant from my conf file: // default settings #define DEFAULTby mickey - Prusa i3 and variants
QuoteKeyserSoze3d Quotemickey OK set the vref and all seems ok but I have a few problems, It seems that my heated bed cant really reach to 110c for ABS printing. I replaced the cable to more thick one(and it helped a bit now I can reach 90c but still take an hour). I check the solder points and they seem fine also I have the folder kit PSU from folger. is there a chance that the bed temp readingby mickey - Prusa i3 and variants
OK set the vref and all seems ok but I have a few problems, It seems that my heated bed cant really reach to 110c for ABS printing. I replaced the cable to more thick one(and it helped a bit now I can reach 90c but still take an hour). I check the solder points and they seem fine also I have the folder kit PSU from folger. is there a chance that the bed temp reading are far from the truth and I aby mickey - Prusa i3 and variants
Quotewaltermixx no software option with the RAMPS board, you will need a volt meter. + cable to the actual metal of the tiny adjustable pot, and - to ground. please use the voltages posted earlier in the thread, the ones i posted from the folks at folgertech as a good starting point smiling smiley Folger guys just publish a complete PDF for the build process. to late for me but at the end they sby mickey - Prusa i3 and variants
Hi I just finish to calibrate my Folger tech printer and I need some help, the one thing I didn't do until now is to adjust the vref of the motor controllers because I don't really understood how do I measure them. is there an option in the host program to read these values?by mickey - Prusa i3 and variants