I completed my first real print!! Thank you for your help & comments Markby jmkslave - Prusa i3 and variants
Thanks for the response guys. I checked the resistance and found that it is at 5 ohms. I read that this is supposed to be between 1 & 1.25 . . . any idea how I deal with that?? Does that mean the board is defective & I should get it replaced? Looking at the back of the board I notice that both negative wires are connected to circuit 2 and then some solder is run over to circuit 3. Seeby jmkslave - Prusa i3 and variants
Hi, I bought my first printer 2 weeks ago and have it built. I was about to calibrate the extruder when I found that the heat bed will only heat up to 44 degrees. I increased the voltage on the power supply to 14v and low and behold got the heat bed up to 49 degrees. I'm a bit lost as to what the problem might be and would love some help. Thanks Markby jmkslave - Prusa i3 and variants