Awesome thanks. Another question. I replaced my bearings and since then if I have Park enabled in repeitier when the print ends or i kill it the Y axis will bounce/grind against the endstop. I've switched endstops and readjusted location etc. If I turn off Park then just the x homes as per gcode. Any idea there lol??by cmenchion - Prusa i3 and variants
Guys how critical is the alignment of the top (z) stepper motors? On the bottom I have like 14" from outside to outside. On the top by the motors the rods are 14 and 1/16th. If I try to squeeze them do they are same distance then z gets rough and doesn't slide nice. I noticed that the top rod on the left side top of x idler mount is very tight and may not be going all the way in. I guess my queby cmenchion - Prusa i3 and variants
I'm on the last step of the manual where I heat the extruder etc. My problem is that only the extruder shows up in repeater. If I switch the thermistor wires the heat bed and extruder show up but the software thinks the bed is extruder and extruder the bed. To heat the extruder I have to click the bed icon and the bed doesn't heat if I click extruder and the bed shows ambient temp(which thinks itby cmenchion - Prusa i3 and variants