Duckfridrice, I know this is a old topic, but I have to thank you for saving my day. 5 to 3 rocks.by Anvoy - Reprappers
Mel0n, thank you for your advises. I will re-level the bed when I go back, but I think my bed is close to level. You mentioned extrusion calibration, could you be more specific on that or direct me to some reference? I also noticed every time when it was extruding the extruded material tend to bend up and stick to the hot end and created a mass down below. I have to kill/restart the print. I belby Anvoy - Prusa i3 and variants
I was using 1.75mm PLA with temp 185/70 for those prints. The layer height was 0.4 and extrusion width was default in rep host.I read online that lower layer height and lower acceleration could help, so I changed the layer height to 0.2 and extrusion width to 0.5 with x/y acceleration to 500. Now I do not see the ripple lines anymore, but new artifacts was introduced. Sorry that I am currently ouby Anvoy - Prusa i3 and variants
I followed the guide on . The extruder motor pins are not corrected on the built guide, and I reversed it. here is a pic of correct one.by Anvoy - Prusa i3 and variants
Hi, all. I brought a forgertech 2020 Pursa i3 and I finished the build two days ago. I was struggling with X-axis homing issue, but found solution at the printer official thread --. Later on When I was trying to calibrate the extruder, I realized the extruder motor pins are reversed in the built guide. So I fixed it and successfully calibrated the extruder. Here are some pictures of my first fewby Anvoy - Prusa i3 and variants