Does anyone have installed à sg90 bed leveling with the melzi 2.0 board ? Can you Please help me to setup mine ? Thank youby hochefab - Prusa i3 and variants
Bonjour, Je travail avec une Prusa I3 Afinibot. J'ai le bed a 115 degrés et l'extruder a 235 degrés. J'utilise du Kapton tape sur mon bed ainsi que de la laque a cheveux. A mon print j'ai rajouter des oreilles de mickey (corner disk). Vitesse d'impression : 50 mm/s Quelque soit le parametrage et la taille des corner discs, j'ai toujours le print qui se soulève du bed. Cela se produit uniquementby hochefab - Canada, Montreal RUG
I solved all my problems, Just change the power supply and setup the output to 13,2 volt. Shunt all the connecter together , the 3 V+ and the 3 V-, it works pretty well with PLA and ABS. No problem for the heat bed to go to 115 degres with ABS and need to wait only 18 minutes. With PLA , 65 degres on 3 minutes and 28 sec. Now i have a very good printer. I can print With 0.3mm layer at 100 mm/sby hochefab - Prusa i3 and variants
I dont known if it's for better functioning but it's not easy to use. I think Ramps or Newest controler board will be more efficient if you need some extra functions like auto bed-leveling, dual extruder or more, etc....by hochefab - Prusa i3 and variants
Hello, I have lots of vibration and noise but you can do this : I think this is a good printer but i had lots of problem with the ABS and the heatbed. Impossible to have a temperature over 104 Celcius, even with some glass fiber between the heatbed and the support. I will buy a SSR40 to override the power of the heatbed. I have pretty good print with PLA. I'm on my way to do another one butby hochefab - Prusa i3 and variants