QuoteMach QuoteLancelotL Has anyone ever tried to run multiple FT2020s off the same computer to print the same thing? I would think it would be easy to do, but I'm not exactly sure how to do it. Is there a USB splitter that would make this possible? usb splitters do exist, but you would most likely run into issues with data being sent back to the computer from the printer. The proper way to doby GravityWins - Prusa i3 and variants
QuoteGravityWins Thanks for the reply tjnamtiw. but still no luck. Here are the steps that I see as well as hopefully a better explanation of the issue: 1) Using the marlin firmware recently (Oct 11th) downloaded from the Folger 2020 google drive. I have modified the configuration.h file to read: #define INVERT_X_DIR false and #define X_HOME_DIR 1 Then saved/complied uploaded to the board. Tby GravityWins - Prusa i3 and variants
QuoteMopar99 Did you tune your driver boards? Adjust the pot on each board to the recommend voltage? I used the Marlin firmware posted about 2 pages back and only needed to change the end stop from 1 to -1 then change rep-host X setting from min to max. Once the was complete, tested it and it worked like it was supposed too. My X limit switch is on the left. Mopar99 - I did not, but while I haby GravityWins - Prusa i3 and variants
Thanks for the reply tjnamtiw. but still no luck. Here are the steps that I see as well as hopefully a better explanation of the issue: 1) Using the marlin firmware recently (Oct 11th) downloaded from the Folger 2020 google drive. I have modified the configuration.h file to read: #define INVERT_X_DIR false and #define X_HOME_DIR 1 Then saved/complied uploaded to the board. Then disconnect USby GravityWins - Prusa i3 and variants
Hoping to get some help with and issue that I am having with my Foger 2020 Prusa. The issue is with the stepper motor on the x axis. all the other axis work fine. The motor only seems to want to go in one direction. When I use Repeier host when I click to move in either the positive or negative direction it moves in the same direction. The very strange thing is that sometimes when I start up tby GravityWins - Prusa i3 and variants