Quotetjnamtiw Quoteamishboy I have had my printer up and running for a while now and recently installed a BLTouch sensor for autoleveling. The autolevelling process seems to work and i see the z axis slightly moving but it appears to not be correcting enough. Below is a picture of my firt layer where you can see that the right side looks good but the left is off. I have attached my configuratiby amishboy - Prusa i3 and variants
I have had my printer up and running for a while now and recently installed a BLTouch sensor for autoleveling. The autolevelling process seems to work and i see the z axis slightly moving but it appears to not be correcting enough. Below is a picture of my firt layer where you can see that the right side looks good but the left is off. I have attached my configuration file also. Thanks in advby amishboy - Prusa i3 and variants
Can someone tell me what the pitch is of these if you have used them and/or the steps/mm when used with the standard Folgertech steppers? Thanks 3D Printer T8 300mm Z Axis Lead Screw 8mm Screw Pitchby amishboy - Prusa i3 and variants
Quotewowzerz Hello Forum! I'm new to the 3D printing scene and just finished the build of my FT 2020 last week. Once I "finished" the build I went over all the electrical connections to be sure they were all correct at least twice prior to ever plugging the unit into the USB or wall outlet. All the connections as listed in the build manual are correct. The configuration given by FT on the Gooby amishboy - Prusa i3 and variants
I bought an 8"x10" piece of picture frame glass from Hobby Lobby for like $4by amishboy - Prusa i3 and variants
QuoteMach Quoteamishboy After getting my printer setup and dialed in and after several prints from SD card i decided to print the auto level parts and get it hooked up. Everything went fine until i plugged in the USB cable to the Mega to test and poof smoke from the arduino. This is my 3rd arduino and second ramps, and i thought everything was great until this, now i wait for another Mega. Anyby amishboy - Prusa i3 and variants
After getting my printer setup and dialed in and after several prints from SD card i decided to print the auto level parts and get it hooked up. Everything went fine until i plugged in the USB cable to the Mega to test and poof smoke from the arduino. This is my 3rd arduino and second ramps, and i thought everything was great until this, now i wait for another Mega. Any pointers on what i shouby amishboy - Prusa i3 and variants
QuoteSteveSimpson I have a Folgertech Prusa i3. I've done the construction and started the configuration. The Arduino is flashed with the Marlin firmware. But when I plug the Ramps board into the Arduino and turn on power the Arduino is not seen by the PC. The error message in Repetier was something like "there is no port". So I ran the Arduino software that I used to flash the firmware. It alsoby amishboy - Prusa i3 and variants