I made a 40 to 60mm adapter and filament cooler. Works well on my printer.by TollBoothWilly - Prusa i3 and variants
I am trying to print this thing. Turtle On the first layer, there are 14 little circular contact points. I can't seem to get them all to stick to the bed. I have tried turning up the bed temp and the extruder temp as well as increasing the first layer thickness and width and printing the first layer slower. I just can't seem to get them to all stick. Any ideas?by TollBoothWilly - Prusa i3 and variants
Quotemsaeger [The E3D Lite6 I upgraded to does not leak at all not yet anyway It actually will start putting down material right when the print starts because it all didn't leak out while heating up like the Folger one would. Defiantly was a good upgrade. What modifications are required to switch over to this hot end? Does the extra length of the heat sink take away from the vertical printing aby TollBoothWilly - Prusa i3 and variants
HI. I just finished assembling my printer 2 days ago and have had fun printing a few things. I did calibrate the axis, but have done no other tuning. All of the settings are the default set in the config guide and presets from Folger Tech. (The guide is here ) A few questions: It looks like in it's current configuration I only have ~150 mm available on the Z axis. Is that normal? I see there aby TollBoothWilly - Prusa i3 and variants