Quoteayryq [email protected] Ok, I just bought the RepRapDiscount Full Graphic Smart Controller. I have added The U8glib library and added the following line to Configuration.h #define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER. Still not working. Any ideas? I have an idea. The copy of Marlin supplied by RepRapGuru is so old it does not support this LCD controller (even though RepRby REPRAPGURU - Prusa i3 and variants
Quotedeadpool66 Hey guys going to upgrade to an e3d v6 what changes need to made to the firmware? the only real change in the firmware should be the value of the termistor. Alot of customers change over using these files: Carriage and Clamp for extruder x-carriage file from here: Compact Bowden for MK7 gear here:by REPRAPGURU - Prusa i3 and variants
the only real change in the firmware should be the value of the termistor. Alot of customers change over using these files: Carriage and Clamp for extruder http://www.thingiverse.com/thing:547706 x-carriage file from here: http://www.thingiverse.com/thing:119616 Compact Bowden for MK7 gear here: http://www.thingiverse.com/thing:767951by REPRAPGURU - Prusa i3 and variants
Try lowering your temp a few degrees in the slicer. It's pretty normal to have some plastic start to come out once at temp but alot of leakage is no good. Some lift the Z axis and heat the hot end in manual mode to find the best melt temp of their roll by adjusting the temps watching for leakage then testing the extruder to make sure it will extrude at the desired temp. Hope this helps. Nickby REPRAPGURU - Prusa i3 and variants
Hey Guys, Nick from RepRapGuru here I wanted to setup an official thread for everyone to post all questions, tips, tricks, and suggestions about the printer kits we offer. Stay tuned for new updates as we are about to release several new printers... Nick RepRapGuru, LLC RepRapGuru.Comby REPRAPGURU - Prusa i3 and variants
Your bolts that hold your PSU in place the bottom 2 to be exact are too long and are shorting your neutral to ground remove the bolts and replace with a M4 8mm. If you purchased your kit from Reprapguru, call us for the replacementsby REPRAPGURU - Reprappers