Show all posts by user
http://reprap.org/wiki/Prusa_i3
Re: How to autotune PID controller for heated bed? - 10 years ago
Thank you for your suggestions! I am adjusting the values in the Arduino code and reuploading it to the board when I tune them if that's what you meant by replacing the values in the firmware and reflashing (sorry I'm still learning this jargon). I haven't used those codes before though so I'll try those before my next print. Edit: Huh. And now it's heating properly. All I've done recentlyby Zannyth - Prusa i3 and variants
Re: Folger Tech 2020 i3 Printer Kit (Official Thread) - 10 years ago
I am having trouble with my bed's heating element it appears. I set the target temperature to 120C for printing (ABS) and the bed heats to this temperature, then slowly continues heating until about 131C where it hovers around consistently. It was getting up to 137C before I just tuned the PID values in the config file, I'm not sure if that impacted this or not though. It's not just going to mby Zannyth - Prusa i3 and variants
Re: P802M Prusa i3 Unofficial Support Thread - 10 years ago
Removedby Zannyth - Prusa i3 and variants
How to autotune PID controller for heated bed? - 10 years ago
Greetings, I'm using the RepRap 2020 Prusa i3 offered by Folger Tech. After assembling the printer, I'm now trying to calibrate everything properly. My main problem right now is that my bed reaches the desired temperature, then continues heating to beyond that temperature. For example, I have it set to 120C for my ABS prints and it is currently at 135.5C and climbing shortly after starting myby Zannyth - Prusa i3 and variants