Show all posts by user
http://reprap.org/wiki/Prusa_i3
Re: Migbot Prusa i3 Unofficial Support Thread - 7 years ago
I'm using a hot air blower (500C air temp, 2000W) to heat up the bed. It takes 2 minutes max of blowing air onto the bed to get it to the required temp.by Boggy22 - Prusa i3 and variants
Re: Migbot Prusa i3 Unofficial Support Thread - 7 years ago
Hi again guys. I did find a while ago that the cause for my filament being stuck was the un-chamfered throat in the extruder. I "dremeled" a nice cone shape at the top where the filament comes in and it went smoothly afterwards. After having a clogged nozzle I decided to dip the hot end in acetone because the aluminum block was dirty too. Stupid thing, because I think the teflon lining inside theby Boggy22 - Prusa i3 and variants
Re: Migbot Prusa i3 Unofficial Support Thread - 7 years ago
Thank you, I might give it a try. Which one should I upload? I have the 220x220x180 bed, no auto-leveling. Is that the large bed?by Boggy22 - Prusa i3 and variants
Re: Migbot Prusa i3 Unofficial Support Thread - 7 years ago
Hi guys, I'm new here, I didn't find anything via search so better ask. I have a Migbot i3 printer setup (acrylic type frame) that I'm very very pleased with. The only problem that I have with it is that it's a bit decalibrated as default. I've calculated that the propper settings for steps/mm must be: X: 80.16 (80 default) Y: 80.24 (80 default) Z: 399.0 (398.2 default) Actually, after workingby Boggy22 - Prusa i3 and variants