So I am sure there is someone out in the community that has seen this before, and I wanted to reach out to get some insight. I did do some searching on the forums, but I was not able to find exactly what I was looking for. I have auto bed leveling on, and I know it works (the z-axis motors move constantly to adjust for the measured bed height deltas). However, I am still seeing quite a bit ofby Swulf1 - Printing
I actually had to swap two of the wires in the harness going to my extruder motor. A standard harness to an extruder has a wire order of red-yellow-grey-green. My extruder harness was red-grey-yellow-green. Once I swapped the two inner wires, the extruder worked fine with no changes to Marlin. Good luck!by Swulf1 - Prusa i3 and variants