Show all posts by user
http://reprap.org/wiki/Prusa_i3
Re: P802M Prusa i3 Unofficial Support Thread - 8 years ago
Quotefaroutmm Have a new Prusa anet a8 i3. Starts up and temp sensors read 24c on extruder and -51c on hotbed for just a second then they both read def. printer seems to be stuck in dry run mode and cannot be switched out. I've tripled check connections, checked voltages, and hit the reset button on board. Any ideas? Please help! I had the same problem with the hot end thermistor. How many ohmsby pmoran - Prusa i3 and variants
Re: P802M Prusa i3 Unofficial Support Thread - 8 years ago
Has anyone had "DEF" displayed on the LCD for the current nozzle and bed temperatures? I tried to print a 64mm ball and after about 10mm that looked ok, the rest of the ball turned into a birds nest. When I tried to do another print, the nozzle and bed heated up (200/55) but before the skirt was finished, both temps switched to "DEF". Could the 2 issues be related?by pmoran - Prusa i3 and variants
Re: P802M Prusa i3 Unofficial Support Thread - 8 years ago
Howdy-I just assembled a Zonestar P802N (no auto level hooked up yet). I have really learned a lot from this thread. Issue: Someone mentioned an issue with their Z-axis rod/screw rod not lining up on top when installing the x-axis supports. I had the same issue on the right side Cause: the right side support was poorly printed from zonestar. The hole for the brass screw guide was flat on oneby pmoran - Prusa i3 and variants